收cang本ye 您好,huan迎来到shang海er号站苆iaoǎ琫r号站苆iaoń叱蟱ei您服wu!    gong作shi间:shang午 9:00 - xia午 18:00 温馨提示:
EHS 网站
热men搜索:
fang火gui、安全gui、化xue品gui、gong业安全锁ju、盛漏托盘、吸fu棉套装等gong业安全yu环保产品;shi验台、shi验shijiaju、通风gui、shi验gui等shi验shi设ji规划、sheng产、安装及配jian;离心机、fang爆gongju、烘箱、超声波清xi机、shui质监测仪qi及shi验shi耗材等共3大lei产品。
产品分lei
品pai专区 >>更多
Ultra-EverDry?ying用指南|shang海er号站苆iao╯hi验shi设备有限公司
Ultra-EverDry?ying用指南
 
.Ultra-Ever Dry? SE 7.6.110 is a solvent based two part (top and bottom) coating system. It is suitable for indoor or outdoor use. The system offers superhydrophobic and superoleophobic performanceand has been shown to maintain a high level of performance
under a variety of conditions and for extended time. The system is useful for non-wetting, anti-icing, self-cleaning, anti-bacterial, and for corrosion protection.
Ultra-Ever Dry? SE 7.6.110是一种溶剂xing涂层(表面和da底两个部分)。蕇hi糜趕hi内或shi外ying用。已经证明其可yi在多种条jianxia和较长shi间内维chi超qiangde疏shui和疏油性neng。该涂层对于fang潮、fang结冰、自洁,**、fang腐shi等都feichang有用。
 
er.Ultra-Ever Dry? SE 7.6.110 yields a matte finish surface that withstands moderate abrasion. The coating is translucent white in appearance depending on thickness used. Ultra-Ever Dry? SE 7.6.110 is applied in two steps using an equal application volume of bottom coat and top coat.
Ultra-Ever Dry? SE 7.6.110 ?SE产sheng一个哑光表面可yi承受适度de摩擦。涂层材料呈半tou明白色白色de浓度则qu决于pen涂厚秖uⅫ/span>Ultra-Ever Dry? SE 7.6.110 ?SEpen涂作业分两个bu骤用相同liangdeda底层和表面依cipen涂。
 
san.CAUTION: Items coated with Ultra-Ever Dry? will have a translucentwhite appearance which could affect the color of the product being coated. TEST ON AN INCONSPICUOUS AREA PRIOR TO FULLY COATING.
注意Ultra-Ever Dry?涂层呈半tou明白色可nenghui影响到产品本身de色彩。所yijianyi您在使用前在一些不显眼de部位xian做一xiashi验,yi确定不hui对您de产品造成影响后再使用。
 
.Personal Protection Equipment:
个人fang护设备:
Always wear the following equipment when applying:
在施gong作业过程中请使用yixia个人fang护设备:
Respirator - NIOSH approved half-face respirator P100 rating with organic vapor cartridge
hu吸qi:NIOSHhe准de半面zhao式带有机蒸汽滤盒dehu吸qiP100
Safety glasses/goggles
安全眼jing/护mu镜
Nitrile gloves
丁jingshou套
 
.Application Equipment Options:
施gong设备选项:
Option A: Pneumatic Sprayer
?选项A:气动penwuqi
Air compressor
空ya机
Conventional gravity fed, pneumatic sprayer, requires two separate sprayers
chang规de自动给料气动penwuqi,需要两把单独depenwuqi
Note: Remove the pre-installed filters in the sprayer head
注意: ba除penwuqi头shang预装de过滤嘴
Air pressure = 20-35 psi (138-241 kPa) nozzle
气ya=20-35psi(138-241kpa)pen嘴
Tip size = 0.020-0.050 inches (0.50-1.27 mm)
顶端尺寸=0.020-0.050ying寸(0.5-1.27mm
 
Option B: Pump Sprayer
?选项B:气ya式penwuqi
Two hand pump sprayers, one for top coat and one for bottom coat.
两个shou动气yapenwuqi,一个用于da底涂层、一个用于表面涂层
Pumps must be compatible with solvent in coating.
气yapenwuqibixu适合于溶剂lei涂料
Xylene for bottom coat and Acetone for top coat.
da底涂层含有er甲苯,表面涂层含有丙酮。
Adjustable tip size to provide fine mist.
可调节depen嘴可yi提供*适合de厚度
 
Option C: Trigger Sprayer
?选项C:扳机式penwuqi
Two trigger sprayers, one for top coat and one for bottom coat. Usually available in quart (950 mL) sizes.
两个扳机式penwuqi,分别用于da底和表面涂层。通chang可提供1夸tuo(950 毫升)容积大小。
Pumps must be compatible with solvent in coating.
扳机式penwuqibixu蕇hi糜谌芗羖ei涂料。
Adjustable tip size to provide fine mist.
可调节depen嘴可yi提供*适合de厚度
 
.Optional Equipments
?fujian设备
Heat gun or blow dryer to speed up drying process.
热风枪或者吹风机用于jia速gan燥过程
Xylene for cleaning     
er甲苯清xi
Spreading Rate (coverage):
涂布率:
150-180 sq ft/gal (3.68-4.42 m2/L)
150-180pingfangying尺/jia仑3.68-4.42pingfang米/
 
.Application:
ying用
Surface Preparation: Remove all oil, grease, dust, dirt, loose rust, and other foreign materials to ensure adequate adhesion of bottom coat. Sanding of the surface with 150 grit silicon carbide sand paper can enhance surface adhesion.
表面处理:qu除所有de油、油脂、粂e尽⑽酃浮⑹杷尚獠慵捌鋞a异物,yi确保da底涂层良好defu着力。如果您使用150#砂纸da磨表面de话可yi提高表面fu着力。
Step 1: Bottom Coat
bu骤1:da底涂层
Shake the can of bottom coat well and pour into dedicated sprayer.Once sprayer is filled to the desired amount, shake well and apply multiple thin and uniform coatings to obtain a wet thickness of 3.0-5.0 mils (76-127 microns). This will form a dry film thickness of 1.0-1.5 mils (25-38 microns). Some agitation during application is recommended. Avoid over wetting or pooling. Allow 15 to 20 minutes of drying time before applying top coat. A heat gun or blow dryer may be used on low setting to speed up drying time.
摇匀da底涂层,倒ru专用penwuqi。注满penwuqiyi后摇匀,多ci薄而均匀depen涂到3.0-5.0 mils (76-127 microns)。当gan燥后厚度hui在1.0-1.5 mils (25-38 microns)。jianyi在作业过程中不停晃动penwuqi。避免过于潮湿de环境和shuichi。da底涂层pen涂后需要等待15-20分钟,待其gan燥后再行表面涂层pen涂。热风枪或者吹风机可yijia速gan燥de过程,缩短固化shi间。
Step 2: Top Coat
bu骤2:表面涂层
A separate sprayer used only for top coat is required. Shake the can of top coat well and pour into sprayer. Once sprayer is filled to the desired amount, shake well and apply multiple thin coats. Do not overcoat. Use an equal volume of top coat to cover the bottom coat. Some agitation during application is recommended.
表面涂层bixu使用一个单独penwuqi。摇匀表面涂层,倒rupenwuqi。注满penwuqiyi后摇匀,多ci薄而均匀depen涂。不要过多depen涂,使用相同deliangfugaida底涂层。jianyi在作业过程中瞙uan蟙e晃动penwuqi。
Avoid over wetting or pooling. The top coat will produce a translucent white appearance.
避免过于潮湿de环境和shuichi。表面涂层将呈xian白色半tou明de外观。
Step 3: Drying/Curing of System
bu骤3:gan燥/固化fangfa
The coating will become superhydrophobic within 30 minutes of the top coat application. For best results, allow 2 hours of drying time. A heat gun or blow dryer may be used on low settingto speed up drying time.
涂层de超疏shui性nenghui在pen涂表面涂层yi后30分钟内呈xian。*jia效果大概需要2个小shidegan燥shi间。如果使用热风枪或者吹风机将jia速gan燥过程,缩短固化shi间。
Step 4: Cleanup:
bu骤4:清理:
Clean tools/equipment immediately after use with xylene. Empty left over top or bottom coat into original containers.作业后立即使用er甲苯清理gongju/设备。剩余de表面或da底涂层倒回原容qi内。
 
.Care and Repair:
维护yu保养:
Ultra-Ever Dry? is a durable coating that exhibit superhydrophobicityand superoloephobicity. After curing the coatings will repel water mixtures and refined oil. Cleaning of the surface should be performed using low pressure water spray. The surface
should demonstrate self cleaning properties under these conditions. Dust and dirt should rinse off easily. The surface will remain completely dry. The surface will lose it properties if treated with detergents, soap, some solvents or high pressure water.
 Due to the natural oils in the skin, excessive handling with bare hands of treated materials can cause a reduction in performance as can severe abrasion.
Ultra-Ever Dry?bixu同shi使用两种涂层fang縮ha蕏ian超疏shuiyu超疏油特性。当涂层完全固化后可yi抵抗shui混合物和精炼油。请使用低yashuipenwu来清xi表面,在低yashui流de冲xixia表面将huishixian自洁。粂e緔i糱a酃fu玣eichang容易被冲xi掉,表面将保chi完全gan燥。xi涤剂、肥皂、某些特别溶剂或是高yashui流将hui影响涂层表面部分性neng。皮肤中含有天然油脂,故过多de徒shou接触pen涂过de表面yi可nenghui因褁ian啬ニ鸲鴝hi表面性nengxia降。
 
 
 
Instructional Video available at www.UltraEverDry.com-or-Scan this QR Code with your smart phone.
 
 
也可咨xun:021-69106488

shang海er号站苆iao╦将wei你服wu!

产品链接:http://www.caisonglabs.com/s04/caisonglabs/sjml/20130308/3049448/1.html
 
Copyright? 2003-2020  shang海er号站苆iao╯hi验shi设备有限公司版权所有
dian话:021-69106488 021-69106624 chuanzhen:021-69106489 地址:shang海市松江区广富羫hi?58弄3号写讂hi?410shi 觭hi啵?01620

沪ICP备13012389号    

沪公网安备 31011402005026号